Why No One Talks About Garages Anymore

How To Repair a Garage Door removing the old door is the first step when installing a new garage door, using manufacturer’s instructions as a guide,the old door is carefully removed, this is done by unlatching the door from the pulley system, the panels of the door are then taken apart, and then the tracks unscrewed, one should be careful by removing one panel at a time so that they do not fall on someone measurement of the areas where the door is to be installed first takes place, these areas include the door opening height and width, the headroom and the back room, after measurement, to both sides of the opening, stops are attached, they should flush with the inside edge of the door jamb, the bottom piece of the new door is then laid out using sawhorses, additionally weather stripping may be attached, hinges attached and handles lifted to piece Next, using a level in order to set the piece properly, the bottom piece is inserted into the frame of the door, after the piece is set in place, the tap nails partway into each jamb, the nails are bent slightly or slant so that they are secure in place, then using the manufacturer’s instruction, the vertical, curved and horizontal pieces of the track are assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
The Key Elements of Great Doors
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
What No One Knows About Repairs
when the vertical tracks are well secured against the jambs, installation of the curved and horizontal pieces takes place, the previous measurements are used when installing the horizontal pieces, the tracks should be levelled in order to make sure they are straight and they should point 90 degrees away from the opening, according to the manufacturer’s instructions springs are then assembled, when attaching the springs to the pulley, the door is lifted to half length and then pulled up the remaining distance, that is basically how to install a garage door